FiloSeal+

The Filoform duct sealing system FiloSeal+ uses our MD+ sealant which is easily applied from a skeleton gun. The high quality, one component, flexible sealant “MD+” is based on a silicon compound that cures with air (Humidity).

After application and full curing the thixotropic MD+ forms a plastic elastomer mass with special qualities effectively sealing and bonding, while providing a high level of durability.

FiloSeal+ is very easy to apply regardless of the type of cable scenario in the cable ducts as it uses a uniquely shaped foam piece which positions neatly around the cables or pipes in the duct.

The unique design of the tri-flexible foam makes positioning and separation of the cables very simple while also providing a backing for the MD+ to be applied on.

This seal is easily installed in vertical scenarios while providing the added security of insuring no loss of components down the duct.

FiloSeal+ is suitable for sealing several cables or pipes contained in one duct and also allows re-entry of the seal to add or remove cables or pipes as required.

• Flexible, one component, adhesive and sealing compound in a cartridge - (310ml)
• High levels of Gas and Water tightness
• Excellent adhesion
• Shows Fire resistance properties
• Resistant against Water, Alkaline, Chemical agents
• Resistant to Hydrogen Sulphide / Methane and many other Gases (NedLab)
• Non corrosive
• Solvent free
• Shock absorbing
• Non toxic, neutral and almost odourless
• Also suitable for limiting the EX-zones during transitions (observe chemical resistance)
• WIMES Compliant, (3.02 clause 7.4.3.2, d & e)
• Suitable for any shaped duct / bore hole / opening
• Quick and easy installation
• A complete kit for one large duct or multiple smaller ducts
• Seals common materials (PVC, PILC)
• Suitable for renovations, can be installed retrospectively
• Over 25 years of operational experience